Vire 12hp model produced Circa 1975-2002.
Identifiable by the spark plug being on the front of the cylinder. Bing float carburettor with seperate bing pump under it. Electric solenoid starting choke originally used.
Vire 6/7/12 OEM- BOSCH-group DYNASTART with nut, key, wiring diagram. 12 months warranty. Loyalty discount on related equipment and free Technical support for life. +£50 refund for your old exchange unit posted back to me, in 14 days, if possible please.
CHARGING REGULATOR ( for BOSCH/SIBA type dynastarts ) with connectors kit, wiring diagram. 12 months warranty. Loyalty discount on related equipment and free Technical support for life. twice as efficient as previous electro-mechanical versions no moving or exposed parts, marine approved 30A rated (reliable unlike lower rated units)
instead of lowering/weakening your engine bearers or rubber mountings or hull, these can be used to relocate the original engine mounting holes higher, wider and a little longer ! 2 x special plates, manufactured by Vire (56622 & 56621 in the original Valmet A4 size parts list )
2 x special Stainless-steel 3mm thick, plates (as new) 4x fitting bolts with washers/nuts(refurbished) make your 'engine mounting holes' ; wider, lower and at the appropriate angle descending towards the propeller custom part, not manufactured by Vire, but stronger and better design
BLUE (2019 uprated version is better fit than original) gasket + also included, the 0-ring (366989) /spacer rubber in the cylinder-top water hole fits: vire 12 original alloy silencer vire 12 stainless steel 'rustfree' silencer (upgrade) re-usable?, if you use hylomar (non-setting sealant) except 'exhaust cement' just around the exhaust hole, then it...
0-ring/spacer rubber in the cylinder-top water hole special high temperature, extra thick, correct diameter, ensuring raised compressible fit to gasket. fitted to cylinder head recess in top starboard side fits: vire 12 original alloy silencer vire 12 stainless steel 'rustfree' silencer (upgrade)
starting solenoid Bosch marinised plastic case and protected non-rusting contacts uprated to 250A instantaneous/125A continuous (double the original Vire standard) ( for all types of dynastarts )
Pair Of Gearbox GEAR/CLutch Bearings For Vire 6/7/12 The pictured gear is for context and is not included
CIRCLIP,(for retaining a GEAR BEARING and clutch) set of 4
2020 improved model choke cable (150cm) , adjuster, adaptor and new TIP this replaces the electric starting choke on a vire 12 engine comes with all you need and instructions to replace electric choke requires the spring and collar from your existing electric choke(you will see only when removed) please see my video on whats involved to fit , so google :...
Vire 7/12 Prop-shaft RUBBER COUPLING CONVERSION KIT (Late Version) enables you to fit the stronger uprated coupling rubber, to a vire 12 or later vire 7 replacethe 3 m10 studs with bolts or stretch over them and fit bushes. ~(youtube videos) 1 of uprated rubber coupling 2 of m10 nuts(tool) 3 of m8 bolts with washers and nuts 3 of m10 bushes, washers...
Refurbished exchange BING carb for vire 12 (model 8/25/179 equiv and others) NOT included ;choke, air filter,throttle lever, pump, hoses (re-use yours)