Refurbished
2 x special Stainless-steel 3mm thick, plates (as new)
4x fitting bolts with washers/nuts(refurbished)
make your 'engine mounting holes' ; wider, lower and at the appropriate angle descending towards the propeller
custom part, not manufactured by Vire, but stronger and better design
1 Item Items
Warning: Last items in stock!
Availability date:
tested/new condition - Stainless Steel, light marks from testing/storage only.
bolt under the engine (4 bolts included), 1 each side (port/starboard)
the 'Z' shape, effectively raises the underside +70mm higher at the front, sloping down (as you would have in a boat) to only 50mm higher at rear gearbox end, you would fit over your vibration mounting/engine bearer.
each rear mounting is displaced 65mm wider in the same fore/aft position as before (width between mounting centres now 380 not original 250) the wider mounting holes are in 2 slots which allow your mountings to be 0-50mm further aft or 50-80mm forward than the original
each front mounting is displaced 65mm wider but a bit more forward/aft than before (width between mounting centres 380 not original 250, length between mounting centres now 285 not original 240)
in fact there are in the wider bases 3 x slots, that allow mounting bolts between 140mm and up to 325mm apart but you could also drill new holes where you want?
the hard part is already dont for you; designed/tested/fitted for the vire engine, and a special down slope incorporated, which would be really difficult to get perfect yourself.