No products
Top sellers
-
PUMP IMPELLER /" IMPELLOR / IMPELER /ROTOR / RUBBER BLADES"
Highest Quality -Impellor / Impeller for the water pump on a Vire 7 or...
£ 24.00 -
-
Vire 7 & Vire 12 Manual 1992 + Parts List
Operators Manual Installation manual Published by a boatyard (now...
£ 0.00 -
VIRE 7 & 12 DRIVE-KEY (woodruff key) for impeller- s/s
Highest Quality -drive key, or woodruff key this is pressed into the...
£ 4.00 -
ignition points , contact set
contact set ignition points youtube videos how to fit and set and...
£ 23.00 -
-
-
Kit for Overhaul/Service of Tillotson Carburettor of VIRE 6/7
Vire 6 & 7 Diapragm Carb Kit (Typically 286/260 models) The...
£ 36.00 -
VIRE 7 Core Plug set (3) Stainless Steel (Freeze plug)
Specially made for Vire motors only. Pressed from stainless steel by...
£ 14.00 -
VIRE NEW carburettor for Vire 7 or Vire 6 (tillotson HL vire)
NEW Tillotson HL carb for vire 7 or 6 (model HL 286A or HL 260A equiv...
£ 160.00
Categories
New products
-
prop Shaft Bearing ( ID 1"/25.4mm )
NOS - special high temp/low friction/low expansion bush bearing this is...
£ 48.00
Suppliers
- Fashion Supplier
List of products by manufacturer BOSCH
-
CHARGE REGULATOR (E/M charging from BOSCH...
REFURBISHED/Tested CHARGING REGULATOR ( for BOSCH/SIBA type dynastarts ) with wiring diagram. 12 months warranty. Loyalty discount on related equipment and free Technical support for life. electro-mechanical version automotive quality, not suitable for salty bilges 20A rated
£ 40.00Out of stock -
CHARGE REGULATOR (solid-state charging...
CHARGING REGULATOR ( for BOSCH/SIBA type dynastarts ) with connectors kit, wiring diagram. 12 months warranty. Loyalty discount on related equipment and free Technical support for life. twice as efficient as previous electro-mechanical versions no moving or exposed parts, marine approved 30A rated (reliable unlike lower rated units)
£ 99.00In Stock -
connector block / connecting rail 4-pole
NEW for 2021 fits above the flywheel holds the 4 wires from the ignition
£ 12.00In Stock -
Cylinder drain plug and washer vire 7&12
plug and washer for cylinder water drain on a vire 7 or 12 Please check your thread in cylinder is ok before ordering
£ 15.00In Stock -
DYNASTART CONTROL UNIT (E/M voltage...
REFURBISHED/Tested (but 40-60 years old!) rare original BOSCH manuf 1960-1980 (obsolete) part number Vire 52111 / bosch 0190219001 CHARGE (0-20A)/voltage (14V) REGULATOR & starting solenoid combined ( for BOSCH (EU) type dynastarts NOT Delco(pacific)) electro-mechanical version (solid state is 2x more efficient charging than this)
£ 140.00Out of stock -
flywheel puller (2021 ultra strong + safe)
Puller kit to remove the flywheel, all vire models NEW 2021, custom designed and tested by myself on all vire engine models this is improved as it is stronger steel, finer pitch central bolt in a hub that stays flat and true unlike previous versions - see full description about the 2021 enhancements
£ 39.00In Stock -
ignition coil
ignition coil youtube videos how to fit and set and diagnose bosch replacement https://www.youtube.com/watch?v=l7L5EolHfts static test using battery https://www.youtube.com/watch?v=YJKKf1FLGcY running test using strobe lamp
£ 110.00In Stock -
ignition condenser / capacitor
Bosch OEM Vire 6/7/12 ignition condenser https://www.youtube.com/watch?v=AI25X6uqdrE
£ 12.00In Stock -
ignition points , contact set
contact set ignition points youtube videos how to fit and set and diagnose https://www.youtube.com/watch?v=sT_IDcJYa84 removing https://www.youtube.com/watch?v=lclSeSUlYlQ installing
£ 23.00In Stock -
-
-
Starting Solenoid / Relay
starting solenoid Bosch marinised plastic case and protected non-rusting contacts uprated to 250A instantaneous/125A continuous (double the original Vire standard) ( for all types of dynastarts )
£ 55.00In Stock
