Vire 6hp engine, had a round cylinder shape, or model 'BV' most commonly with a Reversing gearbox from Circa 1959 model 'BVR'. produced until 1973
VIRE OFFICIAL TOOL kit 2021 for most maintenance and quickly get going, save you time and trips to boat, many essentials and rarely needed tools NOTE: does NOT include flywheel puller, please search for "PULLER" or see website suggestions below or order "TOOL KIT FULL" NOTE: torch requires 3x1.5V-AAA and meter requires 1x9V, however due to courier...
TOOL kit for most maintenance and quickly get going, save you time and trips to boat, many essentials and rarely needed tools NEW 2021, custom designed and tested by myself on all vire engine models NOTE: does include flywheel puller
Pull cord (starting rope) every boat should have one, in case of flat battery or electrical problems. correct length and diameter with secure melted knotted end https://www.youtube.com/watch?v=bVLcWCKSwtw
STEEL EXHAUST PIPE GASKET CUSTOM TO FIT VIRE ENGINE STUD-PITCH CORRECTLY INCLUDES 2 X BRASS NUT (CANNOT SEIZE AND OR LOOSEN STUDS UNLIKE STEEL NUTS)
REFURBISHED/Tested CHARGING REGULATOR ( for BOSCH/SIBA type dynastarts ) with wiring diagram. 12 months warranty. Loyalty discount on related equipment and free Technical support for life. electro-mechanical version automotive quality, not suitable for salty bilges 20A rated
REFURBISHED/Tested (but 40-60 years old!) rare original BOSCH manuf 1960-1980 (obsolete) part number Vire 52111 / bosch 0190219001 CHARGE (0-20A)/voltage (14V) REGULATOR & starting solenoid combined ( for BOSCH (EU) type dynastarts NOT Delco(pacific)) electro-mechanical version (solid state is 2x more efficient charging than this)
refurbished Intake Manifold Assembly: part 59654 aluminium flame arrester/air filter top 2 steel fixing bolts and brass spacers aluminium Elbow new laser-cut gasket( essential with elbow to prevent drips)
Teleflex Dual action (gear & throttle) inboard engine control lever, recommended model for the VIRE inboard engines. (See full description for specific requirements). vire part number 58170 Features • Dual action (throttle and shift in one lever)• Flush mount design • Neutral “warm up” button for throttle only operation • will fit standard teleflex...
Highest Quality -drive key, or woodruff key p/n/ 8999 01432 3mm width (not 2mm width 7/12hp engines have), special height and length to fit as original this is pressed into the pump shaft to drive the Impellor / Impeller for the water pump on a Vire 6 (note this is fatter than Vire 7 or Vire 12 and ~will NOT fit those )
10 micron, disposable, FIRE-RETARDANT METAL Disposable filter for (8mm) Pipe hose (inside diameter) You must have a fuel filter for all vire engines, this one will NOT remove saltwater/water, but it will remove fine salts and grit if you cannot afford a desalinating filter, then please have one of these at least!
40 micron, servicable (may be disassembled to clean) METAL & GLASS Disposable filter for Pipe hose (6mm inside diameter) You must have a fuel filter for all vire engines, this one will NOT remove saltwater/water, but it will remove and grit if you cannot afford a desalinating filter, then please have one of these at least!
Bracket for attatching remote control to gear lever 2 x sides 2 x nuts & bolts BZP steel finish original VALMET part not copy