No products
Vire 12hp model produced Circa 1975-2002.
Identifiable by the spark plug being on the front of the cylinder. Bing float carburettor with seperate bing pump under it. Electric solenoid starting choke originally used.
Vire 12 HP There are 88 products.
-
VIRE 7 & 12 DRIVE-KEY (woodruff key) for...
Highest Quality -drive key, or woodruff key this is pressed into the pump shaft to drive the Impellor / Impeller for the water pump on a Vire 7 or Vire 12
£ 4.00In Stock -
PUMP GASKET
PUMP GASKET 2022 - improved LASER-cut design, easier to align and use, stronger, more accurate. for 7 & 12 hp models (rubber impellor, high efficiency, self-priming) precise thickness required to seal impellor correctly, maximum pump performance, minimum pump wear. top quality specialist gasketmaterial, oil/salt resistant, waterproof
£ 2.50In Stock -
HYLOMAR SEALANT (gasket glue)
HYLOMAR Gasket sealant 40g tube (non-setting) The only gasket sealant reccomended by Vire UK
£ 9.00In Stock -
-
CIRCLIP s/s (for PUMP SHAFT SEAL)
CIRCLIP, stainless steel, (for retaining a PUMP SHAFT SEAL)
£ 2.00In Stock -
PUMP SEALS overhaul KIT
kit for replacing and upgrading your pump shaft seals; 3 x double lipped seals (3 are better than 2 and will fit) 2 x s/s retaining clip (old steel ones rust and not normally re-usable) 1 x gearbox gasket (original thickness to retain thrust bearing clearances) 40g soecial reccomended HYLOMAR sealant printed tips/instructions for removing /replacing gearbox
£ 36.00In Stock -
PUMP SEALS & CLIPS KIT
kit for replacing and upgrading your pump shaft seals; 3 x double lipped seals (3 are better than 2 and will fit) 2 x s/s retaining clip (old steel ones rust and not normally re-usable)
£ 25.00In Stock -
PUMP SHAFT EXCHANGE Vire 12 (£150 refund)
RE-furbished, the shaft seal area is uprated to Stainless-steel, correcting an original saltwater design fault. Exchange; I need to charge you +£150 deposit, refundable on return of your old assembly within 28 days. Then i will refund your £150
£ 299.00In Stock -
CRANK SHAFT SEAL
1 x crankcase SEAL for the Vire engines (If you want a set, please purchase 2x for 6hp, 3x for Vire 7/12) High Quality, double-lipped, type-tested over 15 years by VIRE UK, no failures.
£ 18.00In Stock -
VIRE 7/12 Crank SEAL (3)
Set of 3x crankcase SEALS for the Vire 7/12 engine High Quality, type tested by VIRE UK over 15 years, no failures
£ 35.00In Stock -
CYLINDER BASE GASKET 12 hp
special extra thickness, critical to correct compression ratio, avoiding piston damage, designed only for the 12hp model waterproof paper gasket, special thickness, between cylinder and crankcase check crankcase joint is level, use sealant like hylomar I have a video on youtube about this procedure
£ 15.00In Stock -
ignition condenser / capacitor
Bosch OEM Vire 6/7/12 ignition condenser https://www.youtube.com/watch?v=AI25X6uqdrE
£ 12.00In Stock
