Vire 7hp marine engine. manuf 1970-2002. squarish top(vire 6 has rounded top) and the spark plug is between the cylinder and silencer, not in front like a vire 12
PUMP PLATE NEW RARE ORIGINAL (zero wear) this is the BRONZE plate that fits between the gearbox casting gasket, and the pump housing gasket (vire #52120 in the 1992 parts manual ;page p25 #5) for 7 & 12 hp models (rubber impellor, high efficiency, self-priming)
Gasket Stops fuel dripping at low RPM from the joint between the carburettor and the elbow under the air filter
Support Plate / Bracket(52049) - REFURBISHED supports the controls of the carburettor (Tillotson throttle & early-model's choke) +2 x gaskets (52056) +2 x s/s/ nuts (30602 ss)
Bracket for attatching remote control to gear lever 2 x sides 2 x nuts & bolts BZP steel finish original VALMET part not copy
1 x mount (not 4) 60mm PCD OEM Valmet early model, note it has narrower PCD (60mm) than later model (70mm) Vire 6/ 7 Engine mounting (Steel Oval Base) does not include other fittings - see below
Original part Vire NOS - likley the only one left in the world.
Brand new - you’ll receive polished and shiny Price is high as this is the last known new one , please ask for cheaper refurbished used ones below instead
REFURBISHED USED - you’ll receive polished and shiny
Original Control Instrument Panel made by VALMET stainless steel with decals supports the keyswitch , warning lamp, stop button (3 holes)
BALL KNOB special threaded hole suit Vire 7/12 gear lever super strong plastic ORIGINAL Valmet part not copy
Propshaft cutlass Bearing for P-bracket -88 x 35/21mm (7/8")
this is a special BZP plated steel bush , for protecting weak rubber couplings 3 of these fit over the 3x 8mm studs on the drive flange, after the rubber coupling and before the locknut, ignore writing on packet, nothing to do with dynastart lol , i know better.