Vire 6 & 7 Diapragm Carb (Typically 286/260 models) The picture...
Vire 7hp marine engine. manuf 1970-2002. squarish top(vire 6 has rounded top) and the spark plug is between the cylinder and silencer, not in front like a vire 12
50 micron, disposable, Transparent Disposable filter for 1/4" (6mm) or 5/16" (8mm) Pipe hose (inside diameter) push fit and clip to rubber fuel hose only. You must have a fuel filter for all vire engines, this one will NOT remove saltwater/water/fine salts and particles, but it is better than nothing. if you cannot afford a desalinating filter, then...
Vire 6/ 7 Engine mounting (Steel Oval Base) includes ; Steel/rubber threaded base (70mm PCD) steel BZP stud (50 x M10) 2 x washers 1 x heaight adjusting nut 1 x lock nut
contact set ignition points youtube videos how to fit and set and diagnose https://www.youtube.com/watch?v=sT_IDcJYa84 removing https://www.youtube.com/watch?v=lclSeSUlYlQ installing
Small End bearing - (caged steel needle) this fits in the small (top/piston) end of the connecting rod on a vire 7 or 12 engine number >22000
Piston pin Fits ALL vire engines (6/7/12), ALL years precision machined part, very rare, correct specification, tested 2mm shorter in length than original, so easier to fit
correct part number is 52008 (52208 printed in Denmark manual isincorrect but is fig.17 page 24) Crank pin, Big end pin
Rod bearing (Big end bearing) 52293/6 special high pressure, caged roller bearing, fits between crank pin and the steel con rod fitted on engines (Vire 7 & 12) numbers >22000 note :earlier engines numbered <22000 had a different bearing (52293) to fit the alloy con rods
ignition coil youtube videos how to fit and set and diagnose bosch replacement https://www.youtube.com/watch?v=l7L5EolHfts static test using battery https://www.youtube.com/watch?v=YJKKf1FLGcY running test using strobe lamp
Highest Quality -drive key, or woodruff key this is pressed into the pump shaft to drive the forward gear pinion
Highest Quality -drive key, or woodruff key this is pressed into the crank shaft to locate the flywheel
good working order cylinder, no leaks refurbished by expert - see details below
pack of 4 x Vire 6/ 7 Engine mounting (Steel Oval Base) each includes ; Steel/rubber threaded base (70mm PCD) steel BZP stud (50 x M10) 2 x washers 1 x heaight adjusting nut 1 x lock nut