Vire 7hp marine engine. manuf 1970-2002. squarish top(vire 6 has rounded top) and the spark plug is between the cylinder and silencer, not in front like a vire 12
PUMP GASKET 2022 - improved LASER-cut design, easier to align and use, stronger, more accurate. for 7 & 12 hp models (rubber impellor, high efficiency, self-priming) precise thickness required to seal impellor correctly, maximum pump performance, minimum pump wear. top quality specialist gasketmaterial, oil/salt resistant, waterproof
HYLOMAR Gasket sealant 40g tube (non-setting) The only gasket sealant reccomended by Vire UK
CIRCLIP, stainless steel, (for retaining a PUMP SHAFT SEAL)
kit for replacing and upgrading your pump shaft seals; 3 x double lipped seals (3 are better than 2 and will fit) 2 x s/s retaining clip (old steel ones rust and not normally re-usable) 1 x gearbox gasket (original thickness to retain thrust bearing clearances) 40g soecial reccomended HYLOMAR sealant printed tips/instructions for removing /replacing gearbox
kit for replacing and upgrading your pump shaft seals; 3 x double lipped seals (3 are better than 2 and will fit) 2 x s/s retaining clip (old steel ones rust and not normally re-usable)
RE-furbished, the shaft seal area is uprated to Stainless-steel, correcting an original saltwater design fault. Exchange; I need to charge you +£100 deposit, refundable on return of your old assembly within 28 days. Then i will refund your £100
1 x crankcase SEAL for the Vire engines (If you want a set, please purchase 2x for 6hp, 3x for Vire 7/12) High Quality, double-lipped, type-tested over 15 years by VIRE UK, no failures.
Set of 3x crankcase SEALS for the Vire 7/12 engine High Quality, type tested by VIRE UK over 15 years, no failures
waterproof paper gasket, special thickness, between cylinder and crankcase check crankcase joint is level, use sealant like hylomar I have a video on youtube about this procedure
Bosch OEM Vire 6/7/12 ignition condenser https://www.youtube.com/watch?v=AI25X6uqdrE
10 micron filter removes smallest contaminants desalinatingwater bowl you can easily drain supplied with tails and washers, easy to fit. essential equipment for tilloson carburettor in saltwater environment (Vire 7) input tail is bore 8mm, output tail is bore 6mm (same as modern vire carburettor inlet pipes)